All Aglow Quilt

All Aglow quilt

are All Aglow quilt.  Finished size about 55 by 69-inches.

This blog page is a brief discussion of how I created my second quilt, my All Aglow lap size quilt.  I assume you are either comfortable with the various stages of creating a quilt, or like me, you viewed several different web videos as you learn your way through quilting.

Names of the fabric are listed below but not the quantity that I purchased as I did not have a pattern but just sewed rectangles together.

The thread that I used:  50wt Aurifil.2783 (Medium Delft Blue)

This blog page presents the widths of the strips that I used and how I did the corners.

The front side’s rectangles are the main All Aglow panel, five strips along each side of the panel and then the binding strip.

The back side’s rectangles are the large piece of All Aglow Tree fabric and a strip of the All Aglow Tree fabric along two sides of the larger piece.

Seam allowances:  Seam allowances on the front piece are quarter inch.   Half inch seam allowances for the back piece and binding.

Click any of the photos to view a larger image.
All Aglow fabric

Fabric that I used.

front side strip widths

front side strips widths

back side strips widths

back side strips widths

closeup of 45 degree corner

closeup of 45 degree corner

One thing that did take up a bit of fabric was my decision to do mitered (mitred) or 45-degree corners.

This is a link to my blog page showing me adding 45-degree (mitered) corners to a pillow. The pillow has one border strip going around the inner design. For making the 45-degree turned corner of the quilt, think of the quilt’s five (sewn together) strips along each side around the panel as a single strip and follow the discussion on the pillow’s blog page.

For what I call “the standard way to” mitered corners view Mary Corbet’s website:  This “standard” approach takes a lot less fabric, but I find it takes a lot longer time for me to get it right.

mitered corner folded back/under and pinned.

mitered corner folded back/under and pinned.

For this quilt I sewed five strips along each side of the panel.

When cutting fabric, each strip has added length to enable me to do the folded 45-degree turned corner.

After the corner fabric is turned and pinned, top stitch along the fold starting at a corner of the panel, along the fold and out to the outer edge.

Top stitched corner

Top stitched corner

Finishing the Sandwich (front, batting, back):

Working on the front side I stitched in-the-ditch along each seam. I know this isn’t a strong quilting (I pressed my seams open) but though I will be using this quilt  during the winter holiday season there will be little stress on the seams and I do not plan to wash the quilt (famous last words before someone spills a bowl of soup or cereal near me!).

I like to leave my binding “undone” until I get the quilting sewing completed. Then I check to make sure the quilt stitching has not pulled the overall quilt out of square. Once that check is completed I bring the binding over to the back side and get ready to sew again through all layers of the sandwich.

Back side: Iron the binding under (half inch) along the “raw” edge, pin it to the back side, top stitch along that that ironed fold. When binding is done I do one more straight line stitching, this line about two inches from the top stitching.